They need to find their activation SIM to reprogram the machine to have scan ability.
The optional SIMs include:
- B1 Key SIM
- Scan / E-mail SIM
- Internet Fax / SFax SIM
- IJO SIM (Immediate Job Overwrite)
- JBA SIM (Job Based Accounting)
If an option is not present or the speed setting is incorrect perform the following steps:
- Open Paper Tray 2 and remove the small plastic cover located to the right side of the tray.
- Remove the small plastic bag with the SIMM card(s) from the storage compartment on the paper tray.
- Locate the orange slot on the left side, at the rear of the WorkCentre.
CAUTION: Do not insert the SIM card into the slot until the WorkCentre is at a Ready state. - Line up the black arrow on the required SIM card with the black arrow on the WorkCentre, and then push the card into the slot until it stops and the green LED above the slot begins to flash.
NOTE: If the red LED is illuminated, remove the SIM card and re-insert the card. Make sure the two black arrows are aligned. - Remove the SIM card from the slot when the green LED has stopped flashing.
- Repeat steps 3 – 5, as necessary, for any remaining SIMM cards.
- Insert the SIMM card back into the plastic bag it was packaged in, and store in the paper tray compartment.
- Replace the plastic cover, and then close the paper tray.
- Print another Configuration Report to verify that the purchased features are installed. It may be necessary to reboot the machine for the change to take effect.
NOTE: When a SIM has been installed, it is serialized to that particular machine and cannot be used on another WorkCentre.