Just purchased workcentre 7530 government surplus. HDD has been removed. When starting it seems to be stuck in a loop. No error messages, no way to print test copy.
Question: Is this due to no disk drive? ...or should It work without disk drive other than scanning? I formatted standard WD SATA drive Fat32 and put in hopping to get some type of error code...it just does the same thing stuck on startup.
Question 2: If admin password has been set, will new HDD reset or will this become an issue after drive replacement?
Q3: Any way to test it prior to purchasing new HDD?
Thanks,
jspiess
