We have 3x Xerox WorkCentre 7830 printers, all connected to a Gigabit network (set to auto-negotiate) and running firmware version 073.010.075.34540.
Since the printers were installed a few months ago, the UI has always been slow to respond. This was also the case when the printers operated the firmware they were supplied with (072.010.004.09100).
Recently we purchased Equitrac and eCopy from our reseller which I'm told works solely by accessing a UI hosted on a remote server and nothing is installed on the device. However I am finding the Equitrac/eCopy UI is also very slow, even though the server its hosted on is a very high specification.
We spent over £7K on each of these printers and yet they operate so much more slowly than anything else in the company. Why is that and can anything be done to make them perform better?