Hi Guys,
We got 1 machine Workcentre 5755 and we installed new HDD. We are going to upgrade the firmware and after that we would like to reset all the settings to default. These are the steps I'm going to do:
1. Save the NVM, GP 5.
2. Enter diagnostics, GP 1.
3. Select Diagnostic Routines.
4. Select Copier Routines, 132 NVM initialization-Copier.
5. Touch the appropriate button to select the NVM to be initialized and follow the on screen
instructions. Refer to Table 1, for the functions that are reset to default.
• All Copier NVM.
NOTE: The NVM window will gray out while the initialization is in progress.
6. Switch off the machine, then switch on the machine, GP 14.
7. Enter dC131 location 09-069 TCSensorCtrlVoltage. Set the value to the value recorded
on the NVM sheet stored in the wallet on the rear cover.
Basically, I'm going to initialize NVM,and my questions are,
in number 7, what if there is no NVM sheet stored in the wallet on the rear cover?
and Is this the correct procedure for us to put all the settings back to default? Thanks.